I’ve been working on getting my parent’s home automated via Smartthings, and it seems they’ve bought the one furnace that you can’t easily integrate into smartthings (or any automation hub for that matter). It’s a Rheem Econet HVAC unit, and instead of working like a traditional thermostat it uses t…

I have the wireless EcoNet device on my 50 gal water heater. Not too impressed with the water heater itself as it seems to run out faster than my old 40 but I did toss in the wireless add on, since the rebate covered the cost. All you can really do is just adjust the temp and set vacation mode, but…

I know this thread is a year old but has anyone had success integrating with the Nest thermostat? I spent a small fortune on a Rheem HVAC system last summer only to find out after install it only works with Rheems EcoNet thermostat. The EcoNet is awful and not user friendly. I would be willing to pa…

Here’s what it says on NESTs site Proprietary systems: Proprietary systems use a serial communications protocol to communicate between the system and the thermostat. Nest thermostats can’t communicate with serial protocols, though some proprietary systems can be re-wired by a professional installer…

I do not have a rheem furnace but I have an EcoNet water heater. Here is my DH. I am sure It could be adapted to work with the furnace. [image] bspranger/SmartThings_RheemEcoNet SmartThings_RheemEcoNet - SmartThings support for thee Rheem EcoNet interface

hello, i have a brand new for 2018 Ruud/Rheem… RUUD UETST700SYS thermostat. no one can tell me anything about it. currently it is hooked to a new ECONET enabled a/c only central unit. i have a Buderus boiler. question is… can the boiler be hooked to the thermostat and how should it be wired. …

Hey there! I am a rather unique add to this thread. For 15 years, I was an IT guy - have done everything from PC to full on enterprise in that time. My primary focus was infrastructure, both in terms of networking and back-end compute. To say I understand systems would be an understatement. I now wo…

Rheem Econet connection type between the air handler, AC condenser and thermostat is RS485. RS485 is serial communications only needing 2 wires, one for RX (receive) and one for TX (transmit) the other 2 wires are power and ground. RS485 allows for having more then a single device connected to these…

I’d be happy to put a protocol analyzer on the RS485 bus if anyone’s still interested.

Hi Kevin, Just wondering if you have made any progress on the control interface to the EcoNet protocol (or ComfortControl2 protocol? I have air handler and a heat pump, both EcoNet enabled and would like to try to integrate them in to the OpenHab. Thanks in advance.

Rheem Econet HVAC Control Integration - Reward offered!

Devices & Integrations Device Ideas

Krishna_Meka (Krishna Meka) August 30, 2019, 4:25am 13

I wonder if any one opened econet thermostat to see if it accepts 24v inputs. Any type of interface to legacy controls

Topic		Replies	Views
Rheem EcoNet Community Created Drivers waterheater , dth_hvac	308	57740	May 13, 2021
Rheem EcoNet Thermostat- A/C & Furnace ST integration Devices & Integrations	0	1252	July 5, 2016
Lennox furnace with ecobee3 (or nest) Devices & Integrations	66	56163	May 15, 2025
Econet EV100 z-vent support? Connected Things	20	4854	October 28, 2015
Smart air vents Connected Things	147	63747	June 17, 2020

Rheem Econet HVAC Control Integration - Reward offered!

Related topics