[RELEASE] Enhanced Z-Wave Plus Thermostat Device Handler - Honeywell, GoControl, CT, Linear, Trane, MCO, Remotec

[eicher_ian (Ian Eicher)]

Anyway to add fan circulation to the device type? Ideally it would have an on/off tile that would trigger it to circulate the fan on a “on 10 minutes, off 30 minutes” type schedule.

Here’s a smartapp for doing it, but you can’t turn it on and off without uninstall/re-install:

Thermostat Fan Recirculate

OK. That makes a lot more sense :-). I’m not familiar with the time math you are using so I can’t comment. I am familiar with using runIn() to schedule a handler some seconds in the future but I suspect what you are doing has the same end result. I think you also need to handle the case where the fan in ON and heating or cooling starts. You unschedule() which means, I think that, once cooling or heating call is done (idle), the fan will stay on. I think you can resolve this by sending fanAuto() in your schedule_start_circulate() method. I’m still curious about this code: def eventHandler(evt){ DEBUG("eventHandler: ${evt.value}: ${evt}, ${settings}") if(evt.value == "idle") schedule_start_circulate() if(evt.value == "heating"|| evt.value == "cooling") unschedule() I think yo…