[OBSOLETE] Enhanced Z-Wave Garage Door Controller GD00Z-4/GD00Z-5/Linear/GoControl/Iris/Nortek Device Handler with Switch and Automated Garage Door Open/Close when People Arrive/Leave/Timer [OBSOLETE]

[JDRoberts]

@WTLimitless

Just bought this device. Trying to load your app so that “close it when people leave” or ability to use with IFTTT works. Clicked on link to your app and it requires a password. How can I get your app?

Rboy charges for his code. Most of the community members share theirs freely or have a donate button for after you’ve tried it and liked it.

If you have the Linear GD00Z, I recommend the free device type from
GaryD9 . It’s very popular.

[OBSOLETE] Enhanced Z-wave garage door opener code (for Linear GD00Z and variants)

I’ve modified the ST default “Z-Wave Garage Door Opener” to better work with the “doors & locks” module. As far as I know, this would only be useful for the linear GD00Z device (and variants including the Iris opener.) This will allow you to select your garage door device as both the “open/close sensor” and the “garage door opener relay.” At that point, from within the “doors & locks” module, you can use “open and close it remotely” (and perhaps the other sub-modules that open/close the door.) All this does is to add the “relay switch” and “momentary” capabilities to the type, stubs on()/off(), and defines push() to either open or close the door (depending on it’s current state.) It’s not a perfect implementation, as the “doors & locks” module might show the door as being “stopped” wh…