blebson
(Ben Lebson)
May 4, 2016, 8:37pm
276
You’ll have to create a virtual switch either manually or by using a community SmartApp like the Virtual Device Manager and then you can try out my new SmartApp:
##D-Link Camera Virtual Switch Controller
This SmartApp will allow you to tie a switch (or virtual switch) to any of your D-Link camera’s custom commands.
Want to turn the PIR sensor on/off when you run your ‘Goodbye!’ routine? Done. Want the camera to move to a preset position when someone hits a light switch? Done.
##Installation Instructions:
Add the Github Repo to your IDE with the following settings:
Owner: blebson
Name: dlink-virtual-switch-controller
Branch: master
Go to the “My SmartApps” tab in the IDE and click [image]
Select dlink-virtual-switch-controller (master) from the drop-down menu.
Select the SmartApp in the ‘New’ tab.
Click on ‘Execute Update’
In your ‘My SmartApps’ section of IDE, select open: [image]
When the SmartApp opens, click Publish → For Me
Now, go in…
1 Like