N00bs guide to ST & GD00Z (Garage Door Controller)

Ron · September 29, 2015, 6:54am

Nice job. For the record my code is very much the same as @garyd9 I made some small changes for minor issues I had when using this device code.

Also my code has been moved to this location for easier integration with the SmartThings ide which now integrates with github.

github.com

gouldner/SmartThingsPublic/blob/master/devicetypes/gouldner/rg-linear-gd00z-garage-door-opener.src/rg-linear-gd00z-garage-door-opener.groovy

/**
 *  Z-Wave Garage Door Opener
 *  Z-Wave Garage Door Opener Modified for GD00Z by @Garyd, Copied and modifed by @Ron
 *
 *  Copyright 2014 SmartThings
 *
 *  Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except
 *  in compliance with the License. You may obtain a copy of the License at:
 *
 *      http://www.apache.org/licenses/LICENSE-2.0
 *
 *  Unless required by applicable law or agreed to in writing, software distributed under the License is distributed
 *  on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License
 *  for the specific language governing permissions and limitations under the License.
 *
 */
 

preferences {
    input name: "enableSwitch", type: "enum", title: "Enable Switch Capability?", options: ["Disabled","On=Open","On=Close"], description: "Enable Switch Capability?", required: true

This file has been truncated. show original

N00bs guide to ST & GD00Z (Garage Door Controller)

Customers

Developers

Download the SmartThings App