(EDGE Driver-Mc): Z-Wave Sensor and Child Thermostat Mc

[BartschLabs]

@Armen_Saghatelian

Thank you very much for the suggestion @BartschLabs. Thank you for the great driver @Mariano_Colmenarejo. I tried it in one room with an Aeotec multi-sensor 6. Works like a charm . So far I set up 3 routines:

• Turn on the heater plugin when the thermostat state is heating
• Turn off the heater plugin when the thermostat state is “pending heat”
• Turn off the heater plugin when the thermostat mode is “Off”

Do you think I need to cover other cases? @BartschLabs what are your routines for this?

These are SmartThings routines that I have found to work:

• Turn on the heater when the thermostat state is heating
• Turn off the heater when the thermostat state is “pending heat”
• Turn off the heater when the thermostat state is “idle”

I use SharpTools rules which can combine the second and third into one rule.