Dome Motion Sensor

[diehllane (Brian Diehl)]

You have to add the device handler yourself

[OBSOLETE] FAQ: An Overview of Using Custom Code in SmartThings (SmartThings Classic, Groovy Code)

The original FAQ information in this thread refers to the original smartthings architecture, which was in place through the end of 2022 and a little beyond. Custom code was written in the groovy programming language and ran in the smartthings cloud. As of May 2023, you can no longer add new Groovy DTH‘s or smartapps to your smartthings account. So if you came here because of a link in an old forum thread, or on another site, I’m afraid the Groovy information is no longer usable. All of this was replaced by a new architecture. Cloud to cloud integrations use the smartthings API. Hub connected devices, mostly Zigbee and zwave, now use “Edge Drivers,” written in the LUA programming language. Here’s the official announcement on those: The process for using a custom Edge Driver in the new …

[OBSOLETE] Dome Motion Sensor (Official)

I won’t be converting the Dome Motion Sensor DTH into an Edge Driver so it will stop working once the Groovy platform is retired, but it probably doesn’t need a custom driver This is the Official device handler for the Dome Motion Sensor (Model: DMMS1) Settings Enable/Disable LED - Determines if the LED should blink when motion is detected. Motion Cleared Delay - The amount of time it should wait after a motion event before sending the motion inactive event. Motion Detection Sensitivity - Sensitivity level of the motion detector. Light Reporting Interval - Frequency that it should report light changes. Light Sensor Sensitivity - Sensitivity level of the light sensor. Screenshots [image]   [image] [image]   [image] Important This device sleeps so every time you …