3-way/4-way question

[antivnm]

If you go with a Aeon Labs Micro Smart Switch (2nd Edition only for this use), you’ll only need 1 micro switch and can most likely keep all your current switches. This is the route I’ve been going for 3/4 way switched loads being added to my hub.

There are a few other posts in the community here about this and Aeon Labs has some instructions on this use on their site. Links below.

However, as others pointed out, 3/4 ways switch wiring configurations often vary in different homes. To make this work you may have to rewire some of your current 3/4 way switches OR its possible that you situation would allow you to easily wire this in. Hope this helps.

Wiring Aeon Labs Aeotec Micro Smart Energy Switch G2 (c) into existing 3-way switches

For a 3-way switch application, you should only need one Micro Switch. Here is some documentation about all of the supported wiring options: http://aeotec.com/support/1219-micro-switch-wiring-schematics.html However, I would expect to see 4 wires in a 3-way application… Hot, Neutral, Load, and Traveler Can you also open up the electrical box where the light fixture is mounted and see what the colors of the wires in there are? Edit: I’ll just add that wiring the micro switch in a 3-way application is pretty difficult, and may require some changes to the physical wiring in your house. But we’ll do our best to help ya out here!

http://aeotec.com/support/1219-micro-switch-wiring-schematics.html

http://www.amazon.com/Aeon-Labs-Aeotec-Edition-DSC18103-ZWUS/dp/B008VWAPU4