Is there any way to set Z-Wave Parameters?
For example, my Jasco Outlet and switch both allow setting of Parameter 3 to a Byte value of 1 to change the Blue LED to light when the switch is ON instead of off.
Anyone figure out how to do this?
Is there any way to set Z-Wave Parameters?
For example, my Jasco Outlet and switch both allow setting of Parameter 3 to a Byte value of 1 to change the Blue LED to light when the switch is ON instead of off.
Anyone figure out how to do this?
What device type are you using for that? The Z-wave switch that it detects those Jasco as already has that in the device type.