Hi,
I’ve now purchased 2 Fibaro Dimmer 2 and am testing things in another part of my house before putting the solution in place in its final resting place.
I’ve got the first Dimmer 2 working with the wall switch, powering a light using the DTH recommended above.
I now want to install the second Fibaro above a ceiling light, and have an always-on load to that light and then use the first switch/Dimmer 2 (disconnected from the light) to control that with direct association,
However, I’m not 100% sure which wiring diagram to use - the wiring in my ceiling light is very simple - just the single blue and brown wire (neutral and live?)
Can anyone share how would I wire that so I can then set up direct association via the DTH? The diagrams I’ve seen all seem to have wiring from fuse board/previous light and the switch.
eg,
https://community.smartthings.com/t/fibaro-dimmer-2-ceiling-rose-installation/97824/2
or
APNT-138 - Standard Lighting Circuit using Fibaro Dimmer 2 — Vesternet (Installing in Ceiling Rose)
Is this what I should be following?
Any thoughts appreciated. I’d typically ask my electrician friend but its his birthday today so didn’t want to interrupt him