Voice Control Using Siri and IFTTT (not using HomeKit, just voice text)

[infofiend]

Jason-

Glad to have another JBer here. I’ve felt like the only one for a while!

You just need to (1) set up the ST endpoints you want, (2) copy the http addresses for those endpoints into activate command and then (3) tie those commands to activator.

Here’s a description that I wrote previously - ignore the abort stuff - that might help:

iOS - Using ST Notifications to give you option to run/abort SmartApp code

If you have a jailbroken iOS device, here’s a way to give you physical control over whether to cause an action in a SmartApp to run – or whether to abort an action that your SmartApp is scheduled to run. It requires a little bit of setting up – both on your iOS device and in the ST IDE. The below is an example of how I set up a way to Allow / Abort turning off lights when my iOS device receives a ST notification that my motion sensors detected “No Motion” for X amount of time. Basically, I set up a virtual on/off momentary button, get the endpoint url for that button, and link that endpoint url to an Activator action. In my SmartApp, when it detects the required “No Motion” event from my motion sensor, I send a unique ST Notification, NotiAction will listen for that unique Notification…

Feel free to ask me Qs.

-Tony