I have the v3 hub. Interestingly, I was able to join Channel and Drivers Web UI (smartthings.com), but not any other channel.
Thank you both. I have opened a support ticket.
1 Like
I have the same issue with the channel invitation link.
Further more, the link to
Z-Wave Lock PH v1.00 just shows a spinning graphic but never displays any content.
Open a support ticket. It’s clearly not limited to just one driver or channel. The more people who report it, the more resources they will assign to look into it. 
1 Like
Where do I open a ticket?
See the contact information at the bottom of the following page
1 Like
Is this currently working? I am getting an “internal server error” when trying to do this
Looks like this has might have been decommissioned from ST. 
Internal server error
I have noticed this on several custom edge projects.
Somehow I doubt that, because they don’t generally just yank the rug out announced from under developers.
I’ve been having problems with ST all day, since the wee hours. If I try to edit routines, usually they just completely crash the app on both mine and my husband’s phones. (Both iOS.) I’ve rebooted everything in the house, deleted and reinstalled the app, all the usual troubleshooting stuff. It has settled down in the last hour or so. All of my virtual devices have been working as they should.
Yes, not positive but have noticed this on 5 different custom edge apps when browsing today trying to replace busted routines. They are all still receiving the message.
Really sorry you’re having problems but this appears to be a problem with the SmartThings website. Try closing and reopening your browser tab or wait and try again later.
Keep me posted if it’s not working by tomorrow.
2 Likes
I’m getting a “There was an internal server error” after I accept the terms and conditions.
@nayelyz - A few folks are reporting problems with the channel invitation/driver install web site. Are you aware of current issues?
2 Likes
It’s not just your channel, @TAustin. I just got the same error trying to enrol in the Zooz driver channel.
As I mentioned earlier multiple channels multiple authors. Some channels appear to be working still which is why this seems a bit odd.
1 Like
Hi, @RebelMagpie, @Eric_Seckinger
Is there any chance that you accepted the invitation to those channels and then made a factory reset to your Hub?
Negative, it is also happening on several other channels with several other developers. Also multiple users have mentioned these same issues.
1 Like
I am getting this issue as well.
1 Like
Many people are reporting this problem on many different channels. I have moved these posts to one thread to consolidate them. Go to the top of this thread, and you can see all the many different reports. Started sometime in the last 24 hours.
2 Likes
No, I just installed my first Zooz products yesterday. Have never reset my hub.
1 Like