[ST Edge] Zigbee Driver for MOES 4-Button Scene Switch (TS004F) Plus Some Smart Knob Models

Hi @erickv
I just got Moes Smart button IP 55 , installed your latest driver “button-battery” to device, and the device connect but not act as button.

thank you Haim

Hi, can you please add this fingerprint ti the driver?

Thank you very much for your job

Anyone got this rotatable knob?

Cant find fingerprint data online. Is this working with this driver?
Only 10eur on aliex…

Can you post a link to the AE web page?

Yes, here it is listed among other 2-3-4 button remotes. Something new :sunglasses:

1 Like

Hi. I hope I am in the right place. First of all, thanks for providing these drivers. I have two Candeo 4-button scene switches, which are Tuya-based. They operate perfectly. However, the battery indication has never worked and has been on 8% permanently since I got them 6 months ago. Is there any chance of this being fixed at any point, or is it an issue with the product? The driver name is Button-battery-v1.4.2, version 2022-05-23T01:17:13.041348.

@erickv Hello guys you thinks that this driver can works with this 2 buttons?

Have you tested it ? It probably created 4 child devices, 1 for each switch.

Hi, i have this scene switch _TZ3000_axpdxqgu. Is not showing battery status. You add this fingerprint in your driver as a button and not a battery button. Why?

It takes time until the Battery status is displayed. Sometimes up to 1 hour. You also need good ZigBee network to mesh this information to ST Hub.

Who are you talking to?

Thanks you, it works perfectly !!! I’m from France and I found nothing in french since the migration of SmartThings groovy IDE.

Good job thx!!

Hello Friends - I have 3 scene switches from Moes working fine with the driver (3 and 4 buttons) but I have another one with just 1 button that is not being recognized - anyone knows how to make this one works? Thanks and regards

Can you please share your device Finger Print ?
Use Zigbee Thing MC from @Mariano_Colmenarejo channel:

Hello dotan_shai,

Manufacturer: _TZ3000_4upl1fcg
Model: TS0041
FingerPrinted_EndPoint.Id: 0x01

Can you please share screenshot from Zigbee Thing MC ?
copy the entire picture with as many data as possible

Please note the the 1st FP was _TZ3000_4upl1fcg while in the picture attached it is _TZ3000_4upl1fcj

This should work with @erickv driver. Try install button-battery (latest version) from his channel here:

You’re a life saver! I was using v1.4.1 but there is a 1.4.4 version that worked fine!!! Many thanks! Now the only thing I’m stuck with is my Moes AM43 curtain motor lol

Thans and best regards!

1 Like

Hello @dotan_shai . Did you get a driver that works on that button? Can you send me the driver link. tks