[ST EDGE] Linkind Leak Sensor (model LS21001)

Edge driver for the Linkind Leak Sensor has passed my testing.

If you’re interested in trying it (consider it in beta just like the rest of the Edge drivers), please sign up here:

  1. Use the invite CStup Edge Driver Invitation
  2. Enroll your hub
  3. Click “Available Drivers”
  4. Click the “Install” button on Linkind Zigbee Leak Sensor
  5. In the mobile app, pair your device using + Device → Scan for nearby devices
  6. Press and hold the black button on the bottom of the sensor for 5 seconds and release. The device will beep and the LED will start blinking to indicate its pairing.
  7. Device should be added within 30 seconds.

Some notes:

  1. The device will check in every 2 hours when in the dry state.
  2. When in the faulted (wet) state, it will check in every 5 minutes. Nice feature in case the hub is rebooted while a wet fault occurs.
  3. Battery updates are configured to report in every 12 hours or whenever the level changes by 0.1V or 1%. The device is reporting both its own voltage and percentages, no lookup/translation table is used inside the driver.
  4. LQI and RSSI are captured from each message received from the device. I thought it might be useful information.
  5. The model number listed on the device is LS21001. Internally it reports the device as “A001082”.

This device matches the signature:

manufacturer: LK
model: A001082

If you have any issues or questions please lmk. These have been great sensors, are priced right (~$12 each), use AAA batteries and work great.

3 Likes

Your link goes to Zooz Edge Drivers.

Just checking to see if you were paying attention! Fixed the link above.

1 Like