[RELEASE] Lock User Unlock/Lock Door Notifications and Actions

[RBoy (www.rboyapps.com - Making SmartThings Easy!)]

So to confirm, we’re also seeing the same issue here starting this afternoon. The routines being executed from the SmartApp are timing out @slagle @Aaron and the routines don’t finish their configured actions

@einars since this is a “common” issue with ST from time to time, we’ve written a SmartApp that essentially acts like a backup routines. Thus is a routine fails this SmartApp kicks in and finishes up for it. So far I’ve found it 100% reliable, check it out:

[RELEASE] Mode Change Actions - Open/Close Door/Window/Switch/Lock/Valve/Shade Notification and Actions on Mode Change

This Mode Based Actions app checks the status of devices on a hub Mode change, notifies you and even changes their state if they aren’t in a desired state When the hub changes Mode, the app will check and notify you if the device (door/window/switch/lock/garage/valve/window shade etc) is open/closed, on/off etc and also change it’s state (turn on/off/open/close) for you. This can also act like a backup for a failed/incomplete Routine execution [image] [image] [image] [image] [image] [image] KEY FEATURES: Report and change state these types of devices (turn on/off, open/close etc) individually for each Mode Doors/windows Locks Garage doors Valves Blinds/shades (with level setting) Delayed checking to allow time for Routines to execute or devices to change state after the Mode chan…