And then run Sonoff Connect to find the device. Since the device is already installed you need to go back and do steps 2 & 3. Then go into the IDE and change the device handler that has been assigned to the device to the newly installed Sonoff Dual handler. Go into the device, click the gear icon, and then hit done.
Thanks Eric, have got a handful of little sonoffs running lately with your hard work.
I have a question please…
I am going to wire one into a wall box and fit a wall mounted light switch to the push button to control a ceiling light. I also have another sonoff in the room on a regular plug-in lamp cord.
I want to be able to also control this plug in lamp from the wall too, on a second wall switch (2 gang)
Can anyone suggest how to do this?
Can I wire a second switch to a gpio on the wall mounted sonoff and use this in Smartthings to trigger another sonoff?
Or should I install a second dummy sonoff in the wall with no load attached and just use it as a remote switch, and have smartthings control them together some how?
Hi Eric. Followed your instructions and managed to get the dual device showing in the app. But also the child devices. As you can see in the picture below. Is that normal?
If i change on or off in child device doesn’t reflect on parental device and vice versa.
The first picture is showing the parental device and the child devices after.
Those 3 dual devices are only one. First parental devices the other 2 are child devices.
Is that the normal?
Yes - They have W Report Interval, V Report Interval and A Report Interval.
The IDE Shows:
21:46:29: debug Current value of setting areport is unknown
21:46:29: debug Current value of setting vreport is unknown
21:46:29: debug Current value of setting wreport is unknown
21:46:29: debug updated()
I had clicked on the link at the top of the page for the latest firmware, but that downloads the Firmware for the TH swicthes.
Just noticed you have another Firmware for the POW switches. I have installed the POW firmware (version:2.0.3) and W,A and V are now showing.
However, I now cant get them to stay on for more than about 30 seconds before they switch off again.
Yet the Auto Off time is set to 0 (Disabled)
Even if I set the auto off time to 65536 it swicthes off after appeox 30 seconds !
I wonder if some of the settings for the TH are causing issues. Can you try resetting the device? Plug it in and hold the physical button down for about 25 seconds.
It should flash the LED 5 times quickly (if I remember right). Are you using linux/macos/ or windows to do the initial flash. I believe there is a way to clear the flash from the esptool.
Thanks for reply. I thought you had produced a version for the DS18B20 sensor that if you go into advanced settings on ota update you can select which sensor you want. None of the files I have tried give that option.
The link I posted is the correct one. After you flash it, go to /advanced and there is a “Sensor Type” option that lets you select which sensor is connected.