Hello @jasonxh! I just started using your DTH and everything appears to be working flawlessly with my DZ6HD. Can you explain the 99% bug? When i tap the High button for example it turns the light on to 99% only. I can raise dimmer to 100% but am not sure if the high button should behave this way. Thank you in advance!
The 99% bug was a different one. The generic DTH always turns on the light to 99%, irrespective to the previous level it was set to. The issue you noticed was a result of the discrepancy between zwave level range and smartthings level range. I’ve put in a little tweak to smooth it out.
I don’t think you can do it thaty way. When I linked github to smartthings, what I did was link using my github email address, etc. (I already had one because I had collaborated with someone on anohter project.) Then I created a SmartThings repository, and made it public.
They way to get jason’s code would be to use his link to github.
Is anyone still having issues with these switches even after this new device handler is installed. I have reset to factory specs and changed the device handler to this but the switch constantly says it is offline. when i go into it if I change the dimmer level it kicks back up but fails to sync the status in ST.
Did you install mine, or the one from jasonxh? If Jason’s I can’t speak to that. If it is mine, I’d suggest grabbing a copy of the Live Log and posting that, or messaging me with it. Also, which dimmer do you have? I expect mine would only match a signature from a DZ6HD, so I would not expect it to be selected if you have a DZ1KD.
I’ve run into this once, when the device just doesn’t send any response to the hub, even though it seems to be taking commands just fine. It recovered after I power cycled the dimmer (breaking the circuit). Seems to be a dimmer firmware issue.
My leviton switches are acting up. I am using this DTH for 4 of them, and all were working fine on day 1. Shortly after they all show “unavailable”. No matter what I try (reboot hub, kill app, reset zwave network,…).
However if I go in the switch settings then click done (no need to modify anything), then it becomes available and I can control them until I move out of this screen.
I looked at the live logs, and the devices that show unavailable do not return anything back to the hub (regardless of the command: no confirmation/acknowledgment).
For example, here’s the refresh command with no answer whatsoever:
11:43:00 AM: debug Refreshing with commands [2502, 2602, 7204, 700501, 700502, 700503, 700504, 700505, 700506, 700507, 700508]
@jasonxh, does this never happen to you? Do I have bad switches?