[OBSOLETE] GoControl Door/Window Sensor, Motion Sensor, and Siren DTH

[cozdabuch (Cosmo)]

Kevin,
Is there any way you’d be able to modify this handler to use as integrated smoke detector on a gocontrol door sensor?

There’s a handler for the smokes in this thread:

Connected Smoke Alarms

My weekend project was to integrate my hardwired, inter-connected smoke alarms with Smart Things. I used a post from the Vera forums as a guide My alarms are made by Kiddie, so I got the appropriate relay for my system (Kiddie SM120x) and the Schlage RS100HC door sensor. I paired the Schlage sensor with the ST hub and it was recognized right away, although I did have to log into the web I.D.E. and change the device type to “Schlage Contact Sensor” to get it report properly. I saved the magnet for the sensor for future projects because it is not needed. I have access to one of the Smoke Alarms in my basement, so I mounted another electrical box about a foot away and ran 14-3 wiring. I hooked the black (line), white (neutral), red (inter-connect) of the relay to the new wire I ran from t…

But it was written for a schlage door sensor. It works for a few hours and then fails due to it being for the wrong device type.

You’d be my new best friend.
I’m fine with hacking hardware, but I couldn’t code my way out of a paper bag.