[OBSOLETE] Lock User Management (LUM)

[duncan]

Probably you aren’t getting any response because you aren’t subscribing to the right attribute. Here’s a post I wrote on the Lock Codes capability:

Implementing capability.lockCodes - need guidance on a couple commands

Sorry about the lack of documentation on lockCodes. The capability isn’t finished, so it will likely still change, but here’s the run down: lock.setCode(2, "0486") to set code #2 to 0486 You need to subscribe to “codeReport” to get the result of that, same with lock.requestCode(). The actual code is in the event data, accessed as evt.jsonData.code. Subscribe to “codeChanged” to get notified when codes are deleted or changed manually, if you use lock.deleteCode(3) you should get a “codeReport” with blank code. updateCodes takes JSON format like so: lock.updateCodes('{"code2":"0486","code4":"2626","code5":""}') Note the empty string to delete code 5. lock.reloadAllCodes() will go through and getCode each code in order. You’ll get a big bunch of events so use it sparingly. It’s basical…

Also, user should be an integer, not a string.

The reason you don’t see user codes in the command class list is because it is only available encapsulated by the security command class, 0x98.