# Qubino Flush Shutter Tutorial **URL:** \ **Category:** Devices & Integrations\ **Tags:** alexa, motorizedblinds\ **Created:** [January 13, 2020, 4:32pm UTC](https://community.smartthings.com/t/qubino-flush-shutter-tutorial/183743 "2020-01-13T16:32:51Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![krlaframboise](https://avatars.discourse-cdn.com/v4/letter/k/d2c977/32.png) [@krlaframboise](https://community.smartthings.com/u/krlaframboise)\ **Post date:** [January 14, 2020, 4:17am UTC](https://community.smartthings.com/t/qubino-flush-shutter-tutorial/183743/2 "2020-01-14T04:17:19Z")
Here’s a topic I wrote on integrating Rollerhouse shades with the Qubino shutter module. There’s a link to the device handler I wrote for that device about half way down the page and it allows you to use the device as a dimmer in Alexa and Google Home. Alexa / Google Home commands: - Turn on - opens shade all the way - Turn off - closes shade - Set to \<#\>% - Sets the shade to the specified # with 100% being completely open and 0% being closed. > [@Motorized Roller Shades Project](https://community.smartthings.com/t/motorized-roller-shades-project/146502): > > I wanted to get Motorized Roller Shades for my living room and control them with SmartThings, but I didn’t want to pay 200+ so I decided to build my own. I’ve gone through this process a few times and I’ve made a few mistakes so I figured I’d start there.   Mistakes The first time I purchased cut-to-fit blackout shades at [Lowes.com](http://Lowes.com), but it turns out those have a cardboard tube and it’s way too small to fit a motor. I looked into purchasing just the aluminum tubes online, but they cost more than what I spent on the shades so I ended up using EMT electrical conduit. The conduit was a little bit too large to fit the 3/4" motor I purchased, but I wrapped some masking tape around the drive wheel which gave it enough grip to raise and lower the shade. That’s not a great solution because t… --- _[View the full topic](https://community.smartthings.com/t/qubino-flush-shutter-tutorial/183743)._