[OBSOLETE] Zooz Edge Driver Channel

[MarkTr]

@jfalteisek

is there a way to tie the door state shown (open/closed) to a contact or tilt sensor like was done with the original zooz garage door smart app?

I’m not familiar with the details but that sounds like exactly the use case this driver is intended for:

[ST Edge] Virtual Hub Kit [BETA]

This will be an open beta, as the driver is not expected to need many updates. Any updates will happen automatically if they are released. Those updates will be announced in this thread, so please watch for notifications. There are some other quality virtual device drivers. The intent of this driver is to enable users to create their own smart apps / devices to enable automations that are not possible with their physical devices. For example, associating a relay/contact sensor to make a door. Follow the invite link below to install the driver. This will create a Virtual Hub in a “No Room Assigned” room within the ST app. You can use this virtual hub to create further devices. Here is a Garage Door Example connecting a relay and contact sensor to automate the door. You should consider t…