[OBSOLETE] Keenect V1.2.0, optional separate vo settings for cooling, vent obstruction auto clear

[Mike_Maxwell]

@Cherokee180c

I was thinking a built in safety for the unit itself if it opens too far or gets jammed. Remember I have had the obstruction error on each of these units in the first day. I am starting to think it might be the device handler itself as I have seen some weird behavior where when opening the device in things, the slide bar goes back to closed. So maybe in trying to verify if the vent is open, when opening the device it sends the close command via the slider in the device handler. Anyway first things first, let me get back to the proper device handler that Keen recommends, which obviously is not what ST installed.

Dunno, I think you’re trying to over analyze the device type, I’m currently using the stock published ST DTH (device type), the one Keen says to replace, and I also used @yvesracine DTH, neither of them did anything like what you’re talking about with any of my vents.
I seriously doubt this has anything to do with the DTH.