(EDGE Driver-Mc): Z-Wave Device Config Mc

[JDRoberts]

@GiacomoF

Good evening. I am trying to associate a fibaro Keyfob with the fibaro 214. In the Keyfob I insert the driver, then I select the profile device association group, and here I insert the group 2 and the node address (B9) of the fibaro 214, node endp a 0, set single channel device. When I give the set command it executes it and passes in get showing me the association. Finished restoring the keyfob driver. When the button that sends the command to group 2 is pressed, the fibaro 214 does not execute any command. Where am I wrong?

The configuration change might still be queued on the hub. Did you check the user manual for the device to see if there’s something you need to do to wake it up to accept the configuration change?

See the community FAQ:

FAQ: Configuration Changes for Battery-powered Zwave Devices

Many Zwave devices have various settings (“parameters”) you can change to your liking, with the understanding that on batterypowered devices this can affect battery life significantly. For example, a motion sensor might let you reconfigure the sensitivity, or a temperature sensor might allow you to change how frequently it reports. And quite a few of the new Edge Drivers will expose these parameters on the device’s details page, making it easy to review and change parameter settings. So far, so good. However, it is important to understand that while these changes normally take effect immediately for a mains-powered device, most manufacturers of battery-powered zwave devices design them to only apply configuration changes every 4 hours. Or maybe even once a day. This is done t…

And from the user manual for this device:

Waking up the device:
The KeyFob needs to be woken up to receive information about the new configuration from the Z-Wave controller, like parameters and associations. Use 1st menu position (white) or click and simulta- neously to wake up the device.

FGKF-601-EN-T-v1.1.pdf

It is a good idea to check the user manual for any batterypowered Z wave device if you are going to make configuration changes to see what steps you need to follow.