Need to switch on bathroom lights (ST newbie)

[JDRoberts]

@xdc7

Thanks for the info. This gives me a place to start

Currently, I have a motion sensor and 2 general purpose sensors that came with the ST kit. I’m going to play with these and see if I can find a solution

You might also find the following helpful. (This is a clickable link)

FAQ: Where to locate motion sensor for fastest response?

[image] I have a downstairs hallway that’s perhaps 12 feet long, with a doorway to a spiral staircase at one end (where the picture is taken from) and a door into the garage on the other end. As you can see in the picture, there’s a jog in the hallway. Not seen here are another doorway about 4 feet to the right of the one by the staircase, a bedroom door to the left at a 45-degree angle (you can just make out a bit of the trim on the corner of the wall, near the top), and a laundry room doorway on the right as you go through the jog. The hallway is dark and I want to automatically turn on the lights when I come off the stairway or enter from the garage. I have an Ecolink motion sensor and I’ve tried placing it in each of the four locations marked with circles. (The two near the top are …