MyQ Lite setup error “Error saving unnamed page”

Setting up MyQ Lite with sensor. I get to a blank page when going through setup and click Done and get the error “Error saving unnamed page. Please contact SmartApp developer.”

The most likely cause for error is you don’t have all the device handler code set up and published. What does living logging show in ide? You may want to post over in the MyQ thread so the developer can see your questions :slight_smile:

I have the SmartApp installed but because I haven’t got through setup there are no MyQ devices listed.
Didn’t realize there was a MyQ area. I will find it and post it there.

Thanks

Did you install the device handlers?