Just a Button? 1 button, nothing more fancy?

[mckenph (phil)]

Go the X10 Route. There are plenty out there and you can get them for cheap. Go this route. Been very happy with the integration with Smarthings.

[OBSOLETE] Node Red Bridge for X-10 Devices (Switches, Modules, Remotes, Sensors and Security Modules)

More information *** Set-up 1: Pi3, Mochad 0.1.17, Node-Red 0.19.3 with Raspbian Jessie (updated/upgraded) A) I run "nc localhost 1099" from the Pi command line to show X10 commands the Pi sends or receives via the CM19A RF X10 interface. This is working. I see all the X10 transmit (TX) commands when SmartThings (ST) is used to turn on/off an X10 device. I see X10 receive (RX) commands when I press a button on my HR12A (RF remote). B) Looking at the Live Logs in the ST - I see activity when using ST to turn on/off an X10 device. I do NOT see any activity in the logs when I use the RF remote to turn on/off an X10 device. There are NO errors reported in the ST log. It appears that, with this set-up, the X10 commands sent from the RF remote are not getting to the ST. *** Set-up 2: Pi3, M…