Jasco 14285 40-Amp Outdoor Switch and power metering

[philh30]

Those logs have me wondering if the device is responding to the polling. I was expecting to see something indicating a response in the log - the DTH as posted on the ST GitHub has some log statements that I think should print for each incoming z-wave command.

Correct, you would switch the device type to Z-Wave Tweaker, change the parameter, then switch back. No excluding. There’s an updated version of Tweaker in the post below that should work with the new app.

[OBSOLETE] Z-Wave Tweaker

I found some limitations to the simulator workaround I posted above, where you couldn’t easily specify ranges for parameter and association group scanning that way. So, I ended up doing an update on the tweaker that took all the old tile actions supported in the classic app, and added toggles for each one in the preferences screen to trigger them that way instead. I sent a PR to @zcapr17 but I don’t believe he is actively maintaining this code anymore. You can get the code that will now support all functions in the new smartthings app from my fork of the project at the link below: When you are done using the tweaker and ready to go back to your default device handler, you should perform a cleanup by toggling the “Perform Clean Up” setting to remove unnecessary settings from sticking ar…

Polling a single device like that shouldn’t mess up your mesh, so long as you’re only polling the attribute you care about and not doing a full refresh.