How do I add my lightbulbs to ST. Not showing up when scanning

[Sticks18 (Scott G)]

Try using the device code in the linked post. Don’t worry about it saying it’s for the Kudled bulb. They’re identical to Hue bulbs. You probably just need the endpointId hardcoded and this will do that. You will need to follow the FAQ that @JDRoberts posted for you in the other thread to install this code in the IDE as a new Device Handler, then apply it to your bulbs.

If you can reset them (Hue bulbs don’t reset using the on/off cycling method like the Osram bulbs) and pair them one at a time; it could help you get a better join and not need the custom device handler.

Successfully paired Kudled Color Bulb (Chinese Hue A19 Bulb Copy Cat, $23) with Philips Hue Bridge

Hi Joe Below is the Kudled color bulb device handler code /** * Copyright 2015 SmartThings * * Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except * in compliance with the License. You may obtain a copy of the License at: * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software distributed under the License is distributed * on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License * for the specific language governing permissions and limitations under the License. * */ /* Kudled (via Zigbee) Capabilities: Actuator Color Control Configuration Polling Refresh Sensor Switch Switch Level Custo…