How can I control this? (USSOLID Motorized Ball Valve)

Looking to control this valve here.

It is a 2 Wire Reverse Polarity valve. Says I could use a DPDT switch which would have to be z wave but I am not finding anything cheap and easy…
Any thoughts?

It mentions Arduino I would look at @ogiewon’s STAnything Project:
[RELEASE] ST_Anything v2.9.2 - Arduino/ESP8266/ESP32 to ST via ThingShield, Ethernet, or WiFi

1 Like

I posted this in your other thread asking the same question. Have you looked into using FortrezZ’s MimoLite. Several folks have already done what you’re trying to do. If you have a wiring diagram for that valve, can you post it here? Personally I’d go with the 5 wire because you can get the built in open/close sensor and other good features.

3 Likes

Well there is another valve you could get, where if power is removed, it closes.
Then all would need to use in one of my twenty z wave outlets to turn on and off.
https://www.amazon.com/dp/B06XW8MSTX/?coliid=ID6JX3NJEJ4Y3&colid=1T92PF1PBK32D&ref_=lv_ov_lig_dp_it&th=1

For about 20 bucks more you could get this: (no need for an external switch or relay because it’s all built in with battery backup)

I have these and they work great with SmartThings.

1 Like