# Hello from Toronto: Question about Z-wave Dimmer Switches

**URL:** <https://community.smartthings.com/t/hello-from-toronto-question-about-z-wave-dimmer-switches/18785>\
**Category:** Connected Things\
**Created:** [July 5, 2015, 6:00am UTC](https://community.smartthings.com/t/hello-from-toronto-question-about-z-wave-dimmer-switches/18785 "2015-07-05T06:00:05Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![JDRoberts](https://yyz2.discourse-cdn.com/smartthings/user_avatar/community.smartthings.com/jdroberts/32/56577_2.png) [@JDRoberts](https://community.smartthings.com/u/JDRoberts)\
**Post date:** [July 5, 2015, 6:25am UTC](https://community.smartthings.com/t/hello-from-toronto-question-about-z-wave-dimmer-switches/18785/2 "2015-07-05T06:25:43Z")

</div>

The switches will say “LED compatible.”

Most zwave switches that require a neutral wire will be LED compatible.  
The ones that aren’t are mostly the older ones that don’t require a neutral.

[http://www.homeseer.com/compare-z-wave-dimming-wall-switches.html](http://www.homeseer.com/compare-z-wave-dimming-wall-switches.html)

The reason there are so many forum topics is that many light boxes don’t have a neutral, and people are usually hoping to avoid the expense and trouble of fishing up a neutral by using one of the older switches, but then they run into the bulb compatibility issue.

As far as the neutral wire…if your house was built in Canada in the last 30 years, there will probably be a neutral somewhere, either in the wall or at the fixture. So it’s usually just a matter of “fishing up” the neutral and bringing it to the wall switch. The electrician will know.

> [@Automated Switches: What should my wiring look like? (US Version)](http://community.smartthings.com/t/automated-switches-what-should-my-wiring-look-like-us-version/15473/):
>
> So you want an automated hardwired light switch, but you’re not sure where to start. Well you’re in the right place. The most common requirement of any hardwired automated light switch is a neutral wire. Yes, there are a few…(read very, very, very few) switches that don’t require a neutral, but those will limit you to incandescent only. For those of us using LED, Fluorescent or some other energy efficient bulbs under 20w a neutral is REQUIRED! So what does this look like? [image] This is a diagram of a switch with the neutral run directly to the light. This is not good for automated hardwired light switchs and i would HIGHLY recommend that if you want to automate the light, contact an electrician and have them pull a neutral for you. It’s not as expensive as you think and will save you…

---

_[View the full topic](https://community.smartthings.com/t/hello-from-toronto-question-about-z-wave-dimmer-switches/18785)._
