# GE Jasco Z-wave Smart Remotes (CES 2017) **URL:** \ **Category:** Devices & Integrations\ **Created:** [January 4, 2017, 5:35pm UTC](https://community.smartthings.com/t/ge-jasco-z-wave-smart-remotes-ces-2017/71768 "2017-01-04T17:35:56Z")\ **Posts on this page:** 1\ **Showing post:** 20
**Author:** ![JDRoberts](https://yyz2.discourse-cdn.com/smartthings/user_avatar/community.smartthings.com/jdroberts/32/56577_2.png) [@JDRoberts](https://community.smartthings.com/u/JDRoberts)\ **Post date:** [August 28, 2017, 1:36pm UTC](https://community.smartthings.com/t/ge-jasco-z-wave-smart-remotes-ces-2017/71768/20 "2017-08-28T13:36:13Z")
> [@WRXFanatic](#): > > So, I have a Jasco 2-Button Hub Remote (34184) in my hands but I can’t figure out a device handler for it. Any ideas? I’ve tried “Z-wave Remote” and that didn’t work. Is it a beta device? They haven’t been certified yet as far as I can tell, so there’s no conformance statement to list the commands that it uses. That makes it very difficult to match it to the device type handler. What did it pair as? My guess would be that it will probably use central scene commands, in which case there are a couple of device type handlers that might be modified for it, but if it just uses Association, it’s now a more complex set up because of the way that association changed for Z wave plus. @erocm1231 is usually the US button expert, you could try his device type handler for the Aeotec dual Wall mote. But again that’s using central scene commands. > [@\[OBSOLETE\] Aeon WallMote Dual & Quad - 2 & 4 Button](https://community.smartthings.com/t/release-aeon-wallmote-dual-quad-2-4-button/74834): > > [image] Update: Make sure your device has firmware 1.7 as it seems versions below that are a little buggy. Very cool device. Wall mountable and looks great. Micro USB rechargeable with ability to configure: Color Touch Sound Touch Vibration When making configuration changes you can either a) wait for the device to wake up and have the changes sync over. The wake up interval for this device is 24 hours so if you are the impatient type you can b) press the button on the back for a few seconds. This will wake the device up and the lights on the front will blink orange. At this point the controller will send over its configuration changes. Edit: Forgot to mention that each button supports push and held. So the dual actually has 4 possible button presses and the quad ha… --- _[View the full topic](https://community.smartthings.com/t/ge-jasco-z-wave-smart-remotes-ces-2017/71768)._