GD00Z-2 not opening Chamberlain Model: LW2200 garage opener

[bamarayne (Jason "The Enabler" as deemed so by @Smart)]

Read through this thread.

Is your wall button a simple push button? Or doors it have motion built in? The linear is not compatible with ask that fancy stuff.

Linear GD00Z (Garage Controller) and Wall Switch (with Motion Detector)

Hopefully this post will save newbies (like myself) hours upon hours of troubleshooting! Issue With the GD00Z-4, clicking the garage door opener in the ST app would result in the following… If door is open, app status changes from “Open” to “Closing” If door is closed, app status changes from “Closed” to “Opening” GD00Z-4 would then beep/flash for a few seconds The garage door would not move, nothing would happen As a little background, the GD00Z-4 installed successfully (wired tight in same terminals as wall switch), paired perfect with ST, and even synced up correctly in the ST app when doing the initial 2 cycle (open/close) with the wall switch. Troubleshooting With very little help available through ST or these forums (as no one else is experiencing this issue) and after spendin…