[OBSOLETE] Fibaro Motion Sensor - New device-handler with all settings and auto sync feature

[CSC]

@jbear

Fibaro Motion Sensor ZW5 v.3.2

For v3.2, you should not be using this device handler.
Cyril DTH doesn’t work with the v3.2 sensor.

Use the below device handler.

[OBSOLETE] Fibaro Motion Sensor v3.2

This version only tested on v3.2 of Fibaro Motion Sensor, it may not work on other version. I combined the excellence code from @CyrilPeponnet + the SmartThings code for the sensors and come out with this version. So far I only tested on the following parameters, but it should work with the rest. 20. Tamper - sensitivity. 0 = inactive. Range from 1-121, default = 20… 42. Frequency of LUX reporting 80. Visual LED indicator. 4 - red, 5 - green, 6 - blue, 7 - yellow… 81. LED brightness Release note: The code will perform update for all the parameters when you sync, and not just the changes. This is something that can be improve further down the road. The code will not read existing parameter from your fibaro sensor, seems to have no way to read it at this point of time. It will use t…