I’ve had a fibaro dimmer 2 installed with a retractive switch for about a year. Never touched the settings since it was first installed. Using the stoxk handler.
The initial operation could be describes as:
pressing and releasing the “up” section of the switch switched the lights on at the same level they were before. Double pressing “up” went to full brightness.
pressing and holding “up” slowly raised the lighting level. Release to leave it there.
pressing and releasing “down” turned the lights off.
pressing and holding “down” slowly lowered the lighting level.
Now there have been a few firmware updates to the hub and it’s knacked various bits along the way, later to be fixed. I had noticed a while ago that pressing the “up” button occasionally failed to switch the lights on, but for whatever reason, thought nothing of it. The majority of the time the lights are controlled via software, unless they’re getting switched off in which case its generally the physical switch.
I have finally realised that for whatever reason, I’m now unable to turn the lights on at the switch. Software switches on fine. Physical switch switches off fine.
No wiring has been altered from day one.
I’ve now messed with the settings so much over the past day that I can’t recall how it should be set in terms of parameters.
I’m not sure why or when it’s failed to work as it should (and as it did), but I was hoping someone could tell me which way the parameters should be set? It’s a little frustrating. Thanks!