# Exclude Aeon Labs DSC06106-ZWUS

**URL:** <https://community.smartthings.com/t/exclude-aeon-labs-dsc06106-zwus/14074>\
**Category:** Devices & Integrations\
**Created:** [April 9, 2015, 2:20am UTC](https://community.smartthings.com/t/exclude-aeon-labs-dsc06106-zwus/14074 "2015-04-09T02:20:09Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Hanselljlh](https://yyz2.discourse-cdn.com/smartthings/user_avatar/community.smartthings.com/hanselljlh/32/172150_2.png) [@Hanselljlh](https://community.smartthings.com/u/Hanselljlh)\
**Post date:** [April 9, 2015, 2:20am UTC](https://community.smartthings.com/t/exclude-aeon-labs-dsc06106-zwus/14074/1 "2015-04-09T02:20:09Z")

</div>

I had to replace my ST Hub and being the old one died after I included these two switches I can’t figure out how to re-add them to my network. The manual just gives instructions for excluding them with the use of a mote or controller.

---

<div class="post-metadata">

**Author:** ![JDRoberts](https://yyz2.discourse-cdn.com/smartthings/user_avatar/community.smartthings.com/jdroberts/32/56577_2.png) [@JDRoberts](https://community.smartthings.com/u/JDRoberts)\
**Post date:** [April 9, 2015, 2:34am UTC](https://community.smartthings.com/t/exclude-aeon-labs-dsc06106-zwus/14074/2 "2015-04-09T02:34:57Z")

</div>

> [@Hanselljlh](#):
>
> I had to replace my ST Hub and being the old one died after I included these two switches I can’t figure out how to re-add them to my network. The manual just gives instructions for excluding them with the use of a mote or controller.

There is a forced exclude (also called “general exclusion”) that can be used for any Z wave device. It is under Z wave utilities. [Support@smartthings.com](mailto:Support@smartthings.com) can help you if you get stuck.

[https://support.smartthings.com/hc/en-us/articles/200878314-How-do-I-exclude-a-Z-Wave-device-using-SmartThings-](https://support.smartthings.com/hc/en-us/articles/200878314-How-do-I-exclude-a-Z-Wave-device-using-SmartThings-)

Once you have done the exclude, then do a factory reset on the device. After that you should be able to include it to the new hub.

---

<div class="post-metadata">

**Author:** ![Hanselljlh](https://yyz2.discourse-cdn.com/smartthings/user_avatar/community.smartthings.com/hanselljlh/32/172150_2.png) [@Hanselljlh](https://community.smartthings.com/u/Hanselljlh)\
**Post date:** [April 9, 2015, 5:24am UTC](https://community.smartthings.com/t/exclude-aeon-labs-dsc06106-zwus/14074/3 "2015-04-09T05:24:28Z")

</div>

Thank you very much!!!