Error troubleshooting

[dalec]

@tgauchat

It helps, please, to share the entire code of the SmartApp or Device Type Handler.

Be sure to highlight and format it using the code icon on the editor toolbar (</>).

Thanks for helping. I’m kind of new to ST developing so I’m sorry but I am not exactly sure what you are asking me to share? Where is this “Be sure to highlight and format it using the code icon on the editor toolbar” Is there an example you can point me to so I do this for you?

This is where the entire smartapp code info is located including the GitHub link. I hope that is what you are asking?

[OBSOLETE] 3 Speed Ceiling Fan Thermostat

[image]This smartapp uses any temperature input to control the High, Medium, Low speeds of a ceiling fan based on your desired room temperature setpoint turning on each speed automatically in 1 degree differential increments (adjustable). For example, if you set your desired room temperature setpoint at 72, the low speed comes on first at 73, the medium speed comes on at 74, the high speed comes on at 75. And vice versa on decreasing temperature until at 72 the ceiling fan turns off. A notable feature is when low speed is requested high speed is turned on briefly to overcome the startup load then low speed is engaged. This mimics the pull chain switches that most manufacturers use by always starting in high speed. There is a motion option so that the fan turns off automatic mode when no …