philh30
February 22, 2022, 12:51am
4
It’s not much more than that. Make sure you download the entire zwave-siren folder and preserve the folder structure. After adding your fingerprint, you would follow the steps in the tutorial below in the “Uploading Your Driver to SmartThings” section.
Creating Drivers for Z-Wave Devices with SmartThings Edge
SmartThings Edge is our new architecture for Hub Connected devices that uses Device Drivers to execute commands locally on SmartThings Hubs. In this tutorial you will learn how to create a SmartThings Edge Driver for a Z-Wave device - the Aeotec Z-Wave MultiSensor 6 .
Prerequisites
Samsung Account
Any version SmartThings Hub with firmware version 38.x or greater
Set up the SmartThings CLI according to the usage section in the repository.
You will be using the CLI to interact with and publish drivers. If you need instructions on installing the CLI you can find them here [Install CLI Tutorial Link].
Edge Drivers are written in Lua, an easy-to-use scripting language. If you are not familiar with Lua, here are some good reso…
1 Like