Duplicate 'switch' attribute in IDE for Z-Wave devices

Reading about a misbehaving Z-Wave relay on Facebook a few minutes ago, I noted that a screenshot of the device page in the IDE showed two entries for switch in the Current States section. I was about to point out this curiosity when I thought I should check my own location. I only have four Z-Wave devices, all assigned the type Z-Wave Switch Generic, and those all have switch attributes topping and tailing the Current States. All my other switches seem to have the traditional one.

I don’t think it breaks anything, it just looks odd.

I see the same for devices using Z-Wave Switch Generic and Z-Wave Switch. No issues noticed.

1 Like

Tagging @Kianoosh_Karami

1 Like