Hello,
@manu, thank you for your prompt reply. After following your instructions I was able to see and run the Touchlink option in the WebApp, but it is never finding any device (even new lamps never assigned to any network, or lamps assigned to deCONZ formed networks). The lamps were held right next to the RaspBEE board. I believe that the problem is that I cannot re-flash the RaspBEE shield.
To explain what I have and what I’ve done: I do have a Raspberry Pi and RaspBee shield (two of each actually), and I had deCONZ version 1.14.03 already installed. In the past when I ran the web app, I saw the update message, but was never able to get it to update properly (just kept giving …), Your instruction to do $deCONZ-autostart.sh worked correctly to get a number of file updates, but it appears to have failed when trying to re-flash the raspBEE shield. The message that came up was
"2015-06-18 12:12:09 (268 KB/s) - `/home/pi/otau/14010400_0x0005.zigbee’ saved [157271/157271]
14010400_0x0005.zigbee: OK
deCONZ - exit code 46
GCFFlasher V1.02 © dresden elektronik ingenieurtechnik gmbh 2013/07/11
using firmware file: /home/pi/raspbee_firmware/deCONZ_Rpi_0x1a0a0500.bin.GCF
reset target
error: RaspBee shield not responding
/dev/ttyAMA0 used by other application?
delete /var/tmp/deCONZ-update-firmware.sh"
I tried to perform the flash “manually” by exiting deCONZ and entering the command line to GCFFlasher. I did this both without restarting the pi, and with restarting the pi (power cycle) - in all cases always the same message about ttyAMA0 used by other application. I am able to run deCONZ without problem or conflict, and I can run the “GCFFlasher -r” and get “SUCCESS” for a reset. I had already edited the /boot/cmdline.txt and /etc/inittab files as instructed for the deCONZ install.
The results when I tried to manually flash the RaspBEE were (note that I first did a reset to confirm that the GCFFlasher was communicating with the RaspBEE properly:
"pi@raspberrypi ~ $ sudo GCFFlasher -r
GCFFlasher V1.02 © dresden elektronik ingenieurtechnik gmbh 2013/07/11
reset target SUCCESS
pi@raspberrypi ~ $ sudo GCFFlasher -f /home/pi/raspbee_firmware/deCONZ_Rpi_0x1a0a0500.bin.GCF
GCFFlasher V1.02 © dresden elektronik ingenieurtechnik gmbh 2013/07/11
using firmware file: /home/pi/raspbee_firmware/deCONZ_Rpi_0x1a0a0500.bin.GCF
reset target
error: RaspBee shield not responding
/dev/ttyAMA0 used by other application?
pi@raspberrypi ~ $"
Is there any way to determine what binary image is flashed on the RaspBEE shield? There doesn’t seem to be a command on GCFFlasher to read the flash image or any info about it. Is there some way to determine the version from one of the apps? Is there something else I need to do to be able to flash the RaspBEE shield?
What next step would you suggest?
Thank you in advance for your help. Mike