One of my zwave GE switches stopped responding and after the usual diagnosis, my only choice was to replace the switch with itself. Was successful and switch is working again. One important note, the previous Zwave address for the device was “1A”. Now the device is listed at zwave address “33.”
Everything is working, but now when I try to run a Zwave network repair, I continue to get errors referencing the old device address, “1A.” Attached below are the errors.
Network repair for device [1A]: Failed to update route
Network repair for device [1A]: Failed to update mesh info
Is there someplace I need to clean up the device? Or is there a way? Like I said, the switch is now at address "33."
Thanks!