[Depricated] Lock Code Manager

[desertblade (Ben W)]

So if the hub goes down,the Internet is acting up the lock or there is a power outage the code does not work?

edit:
This post talks about codes getting “sent down” so they must be stored on it.

Helpful Hints -- the Kwikset 916 Lock

Hi all, I just recently installed one of the Kwikset 916 locks and after dealing with getting it to work with the User Lock Manager and the new device type, I thought I’d pass along some helpful hints that might help others in the future. I’m going off of memory, here, so if it’s not exact, I apologize. Also of note, my door and my hub are probably a good 20 feet away from one another through three walled areas on the same floor and the signal will reach. Get the Updated Device Type. First, head out to grab the updated Zwave device type (zwave-lock.groovy) on @ethayer’s [github] (https://github.com/ethayer/user-lock-manager). Copy the code from zwave-lock.groovy. Go into the SmartThings developer IDE and add a new device type under “My Device Types”. When you eventually add the loc…

and the manual talks about deleting codes from the keypad

916-installation.pdf