Hi all UK based here and I have done a search with no real UK products appearing. Looking to add a ceiling fan to smartthings. It has a wall switch (2 gang - 1 for fan, 1 for a separate ceiling light) to power it on/off, along with a pull switch at the fan for three speed levels, and again the fou…

As you’ve noticed, there aren’t a lot of choices for the UK. :disappointed_relieved: I think the most likely one, and it’s going to depend on the specific wiring in the ceiling rose for your fan, is the following sonoff model: [image] SONOFF Smart WiFi Ceiling Fan&Light Switch Contr…

[image] JDRoberts: another general solution would be one that uses Ifttt, but since they are going through a major business model change right now, I am reluctant to suggest investing in anything that will depend on that, since my own concern is that it may go away all together in the next year. …

I believe both @hongtat and @Richierich have been using The Sonoff ifan03 with SmartThings And may have some additional comments. :sunglasses:

[image] JDRoberts: I believe both @hongtat and @Richierich have been using The Sonoff ifan03 with SmartThings And may have some additional comments. :sunglasses: Hopefully they will chip in for me then :slight_smile:

Hi I’ve been using a ifan03 flashed with tasmota. Note you can only use with ac fans not dc fans I’m looking at a dc fan about to be released with a Tuya controller. But dc fans appear to be lacking integration. My ifan03 controls the fan but is not connected to the light… instead it’s activatio…

Yes. I’m using ifan03 with Tasmota firmware and Tasmota (connect) .

[image] hongtat: Yes. I’m using ifan03 with Tasmota firmware and Tasmota (connect) . OK great info thanks So im a newb, so is the flashing quite easy - I dont solder but can get someone to help there. Other than that the process looks straight forward!!

I don’t solder too - I use pin header and wire, just need to hold it firmly to complete the flashing. It takes a few retries to get it right.

[image] hongtat: I don’t solder too - I use pin header and wire, just need to hold it firmly to complete the flashing. It takes a few retries to get it right OK great, if that works I will try that way first

Ceiling fan control - no light (UK)

Devices & Integrations

denz1968 (Denzil Phillips) September 30, 2020, 9:39pm 7

I don’t have a light so that complication is removed. It’s just a three speed fan

1 Like

Topic		Replies	Views
I need smart fans! Help (UK) Devices & Integrations	4	1069	June 17, 2022
Control Ceiling Fan w/o Wall Switch Devices & Integrations	12	4786	February 3, 2017
Ceiling Fan Recommendation (for use with ST)? Devices & Integrations	5	11708	November 25, 2018
How do I do this? Light switches and fan controllers Projects & Stories	7	1292	March 11, 2019
Controling ceiling fan and light with one switch? Projects & Stories project_hvac	14	68446	June 6, 2018

Ceiling fan control - no light (UK)

Related topics