Cannot pair ge motion light switch after hard reset

Hi community

I am new to ST
I have a few ge jasco smart motion sensor light switches, they were connected to ST hub v2, however, I had to do a hard reset in the hub and now I cannot pair them again

I did the general device exclusion, however when I click add a thing afterwards nothing happens, any suggestions about pairing this type of switch?

I also had a ge smart switch that I was able to reconnect to hub, but it has paired as a wall switch, not as a light switch, how do I Change it to light switch ?

Thanks for your help

Ā© 2019 SmartThings, Inc. All Rights Reserved. Terms of Use | Privacy Policy

SmartThings; SmartAppsĀ®; Physical Graph; Hello, Home; and Hello, Smart Home are all trademarks of the SmartThings, Inc.