Bosch PIR Sensors

Hi

Just wanted to share my experience of using these with the V3 hub. I purchase 3 of these via Amazon.com so they were shipped from the states. I pre-prepared the IDE with the DH I found in this community

Thank you for that thread it really helped.

Once the device handler was in the IDE adding each PIR was very simple and worked first time.

The only downside I can see is the time lag between detection which I believe is 3 minutes. I think this needs to be configurable. That said different locations would ideally need this to vary between locations and I cant see how this could be done with a single DH across multiple devices.

But in general very good product that appears to be pet safe and worked first time.

1 Like