Thank you!
In the SmartThings Classic version, there was this automation tool which was basically a way to run everything all in one. I just tried to replicate this using the automations feature of the new SmartThings app and it took about 6 separate automations to do so.
In the SmartThings Classic app, I could program a set point of 77 degrees where the fan will turn off. If it was 78 degrees, fan would go on low. 79 degrees, fan would go on high. 80 degrees, fan would go on max. The fan would only turn on if there was also motion detected in that room by my Ecobee sensor AND if the ST location mode was “home”. This was done all in the same automation “app” (image below)
I saw the same automation pop up in the “Smart App” section of the new app but it does not work.
Do you know if there’s a way to make it work again in the new app? I’ve attached an image of what it pops up as under “Smart Apps”
