[OBSOLETE] GE/Jasco Z-Wave Plus Dimmer Switch With Double-Tap

[Davefromcamp (Dusty Ward)]

Thanks,

I came across this great device handler when looking if my GE switches could do scenes.

A few tips, This was helpful:

[OBSOLETE] FAQ: An Overview of Using Custom Code in SmartThings (SmartThings Classic, Groovy Code)

The original FAQ information in this thread refers to the original smartthings architecture, which was in place through the end of 2022 and a little beyond. Custom code was written in the groovy programming language and ran in the smartthings cloud. As of May 2023, you can no longer add new Groovy DTH‘s or smartapps to your smartthings account. So if you came here because of a link in an old forum thread, or on another site, I’m afraid the Groovy information is no longer usable. All of this was replaced by a new architecture. Cloud to cloud integrations use the smartthings API. Hub connected devices, mostly Zigbee and zwave, now use “Edge Drivers,” written in the LUA programming language. Here’s the official announcement on those: The process for using a custom Edge Driver in the new …

Then I had to change the device in the IDE.

I did not have to forget the device and add it again. To use the new functions in webcore I also had to “add” the buttons in webcore. Through settings-add device- category 1

This is how I’m using the double tap feature. Up is increasing the lights to 100 percent. Down turns off all the lights in the room.

Thanks again!!