I also use a modified version (see below) of this piston (by @bangali) that’s discussed over on the webCoRE Community forum. There are a couple of variations discussed, one is for a smart bulb/dumb switch and the other is for a smart switch/dumb bulb.
I’m using one like the smart switch/dumb bulb version in my workshop. Under normal circumstances, turning the light on with motion and off after two minutes of inactivity works fine. However, if my wife will be working in a somewhat ‘hidden’ corner and not moving very much while there, making the light stay on is desirable.
Just change the defined variables at the top and it should work. My version uses two sensors but you can use this with just one by removing one and changing the other to yours. Anyway, here’s my version:
