Automate using gps, certain time, turn on then auto turn off

[JDRoberts]

I’m tired, so someone else will have to help you with the details, but see the following post (this is a clickable link).

There are many different ways to do it. If you always want the light to go off after the same amount of time, just use the power allowance feature in smart lighting.

If you want it to sometimes go off after 15 minutes but at other times stay on for longer, you’ll need to use one of the more complex options in the post.

So as with many use cases, smart things is very powerful, there are multiple ways to solve the same problem, but none of the solutions are intuitive.

Skybell not turning on lights in SmartThings (want a timer)

I don’t have a Skybell, so I can’t check this, but if it shows up as a Motion sensor in smartthings, it’s very easy to have motion trigger a light to come on for a specified number of minutes and then go off again using Smart Lights. [image] If instead, you want to have the light come on when the button is pushed and smartthings recognizes that button as a “button controller” there are three ways to do it. One) you can use the power allowance option in Smart Lighting, but if you do so, the light will always turn off after that amount of time no matter how you turn it on. That might meet your use case, or it might not. see the article in the community – created wiki on how to use smart lighting to create a virtual timer. This uses one virtual switch and three smart lighting automat…