# Aeotec DSC18103-ZWEU Z-Wave Micro Smart Switch **URL:** \ **Category:** General Discussion\ **Tags:** uk\_ie\_specific\ **Created:** [February 9, 2016, 6:43am UTC](https://community.smartthings.com/t/aeotec-dsc18103-zweu-z-wave-micro-smart-switch/38579 "2016-02-09T06:43:48Z")\ **Posts on this page:** 1\ **Showing post:** 24
**Author:** ![cscheiene](https://avatars.discourse-cdn.com/v4/letter/c/7bcc69/32.png) [@cscheiene](https://community.smartthings.com/u/cscheiene)\ **Post date:** [May 25, 2016, 8:17am UTC](https://community.smartthings.com/t/aeotec-dsc18103-zweu-z-wave-micro-smart-switch/38579/24 "2016-05-25T08:17:15Z")
Used this code: > [@Aeotec DSC18103-ZWEU Micro Smart Switch (2nd Edition) no Watts](https://community.smartthings.com/t/aeotec-dsc18103-zweu-micro-smart-switch-2nd-edition-no-watts/39809/5): > > In essence the changes from the outlet standard code are changes in the config messages to the device and then reading the data it sends in the correct format. Also I know understand as stated the Configure button is a one time needed thing to send the config to the device and the kWh is an cumulate number. Other than that, I’ve added some debug logging and tarted up the device page tiles. /\*\* \* Copyright 2015 SmartThings and gpsmith \* \* Based on original implementation by SmartThings but fixed some of the issues. \* \* Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except \* in compliance with the License. You may obtain a copy of the License at: \* \* http://www.apache.org/licenses/LICENSE-2.0 \* \* Unless required by applicable … works great --- _[View the full topic](https://community.smartthings.com/t/aeotec-dsc18103-zweu-z-wave-micro-smart-switch/38579)._