Yep, but you’ll have to remove it from all SmartApps first. This could be inconvenient for you.
What you could do is a factory reset from within the DH. Look down at the configure section, just past the statement “def cmd = delayBetween([”.
If you remove the “//” from the line that describes the factory reset zwave command, and add a “//” in front of all the other lines that start with “zwave.configurationV1”, you can do a reset without having to redo all your smartapps.
Once you make that change, tap on Configure tile, and then go back and undo the changes, and go back and tap on Configure again.
This won’t remove those rouge values you see. Those will only go away by a real exclude, delete, and reinclude process.
OK excluded it and reinstalled now have this in devices. Is this correct as right now no cost shows. If it is correct do I try the other DH? When should it show cost? Still says 0.00
Here is what is in live logging: And I have .0.01 in cost so it is working. But now the logging to Google has stoped. I did re add it to the Simple Logger. This is getting frustrating.
Added code for Health Check capabilities/functions
Removed code no longer needed
Added another parameter in Preference to enable or disable the display of values in the Recently tab and device’s event log (not Live Logs). Default is not to display. Enabling may be required for some SmartApps.
All the ones listed I have with the new version the remnants from the old I have nothing in I pressed the X along side and made them 0 I hope this works now. I still only have $0.01 cost my cost per kwh is 0.039630 and 0.29 kwh used, Is that about right?
New DH works like a charm. Thanks again. I have been taught a valuable lesson If I get strange things in a DH, 1. it could be just a bad DH that I tried, which screwed up the good DH. 2. If I x out the bad numbers and restart the app the DH repairs itself sometimes.
eric, I can try to help. Have you downloaded the File for the DH? If not pick one from post 70 just above and open and copy all the code… There is one for using without a battery ( with USB Power) or one for use with 4 AA cells. Once you have that.
Click in the right hand corner where it says Create New Device Handler
In the window that opens click from Code
Paste the code into the window
Click create button on the left bottom
Now click save button in center right of screen
It should now say created or something like that
On the next screen click Save then Publish (FOR ME)
Now that it is published the Device Handler is ready
Now if you haven’t installed the HEM do it. After it is installed and Paired let us know. I don’t think I will be up as it is late here but I will be around tomorrow or someone will be.